Vacuum Chamber Digital Heat Pad - Multiple Sizes

Fahrenheit Heat Pad with Digital Controller (for Vacuum Chambers)

Dial in consistent, repeatable heat for degassing and curing with this peel-and-stick Fahrenheit heat pad + UL-listed digital controller. The pad bonds to the bottom of your chamber and includes stand-off bumpers to lift the assembly off the work surface for airflow. A silicone-gasketed chamber acts as a heat sink, so the controller supports temperature offset to match the actual internal surface temperature. Use the included thermal labels (or a thermocouple/IR gun) to confirm and fine-tune your setpoint.

Available Sizes

Round pads sized to match your chamber (sold separately): 4″, 6″, 9″, 10″, 12″, 14″, 16″ • Rectangular pad: 5.5″ × 7″.

What’s Included

• Adhesive-backed Fahrenheit heat pad
• UL-listed digital temperature controller (1° setpoint resolution)
• Stand-off bumpers and thermal tape
• Thermal indicator labels for offset calibration
• Full instructions (including PID/offset programming)

Key Features

• Accurate & stable: holds temperature within about 1°F (environment dependent); controller accuracy ±0.2°F
• Easy calibration: program a temperature offset so the inside surface of the chamber reaches your target (example: if the controller is set to 110°F and the internal label reads 101°F, set a +9°F offset so the inside hits 110°F)
• Continuous duty: designed to run for extended periods without off-time
• Simple install: peel-and-stick backing; thermal tape included

Notes

• Chamber not included. Choose the pad size that matches your chamber bottom.
• Setpoint will differ from internal surface temperature until offset is calibrated with the included thermal labels or a thermocouple.
• Stand-off bumpers may not adhere well to silicone; verify placement on your work surface.
• Always monitor during initial runs and do not exceed 160°F.